Side-Power SEP 100/185 T Instrukcja Obsługi Pobierz pdf (Strona 170)

911 - 6 Page Date: 4. Februar 2011

Pilot´s Operating Handbook

EXTRA 330LX

Section 911

BECKER ATC 4401 Transponder

1 Storing a new VFR code:

a Set the code to be stored in accordance with section B.

b Press store push-button STO (J), the set code then flashes.

c Press the VFR1 push-button (F) or the VFR2 push-button (G) wit-hin 3 seconds to store the code

under the corresponding button.

d If neither button (F) or (G) is pressed within 3 seconds, the flashing stops and the storage

operation is aborted.

N O T E

If one of the two buttons (F) or (G) is pressed without the STO button having been pressed

beforehand, then the stored code allocated this button appears in the code display and is

switched to active after 3 seconds (can be changed in the configuration mode). If the same

button is again pressed within 3 seconds, the previous code appears.

2 Activation of the VFR codes:

a Press the VFR push-button 1 or 2 (F, G). The selected code is then displayed. After 3 seconds,

the displayed code becomes activate and overwrites the previously-set reply code.

b Pressing button (F) or (G) again within 3 seconds reactivates the previously-set reply code.

N O T E

When the unit is delivered, the store buttons are not assigned a code. This means that if

these buttons are pressed for 0.5 seconds, „——“ is shown in the code display and the

transponder then switches back to the previously-active code.

IMPORTANT CODES:

1200 The VFR code for any altitude in the US (Refer to ICAO standards elsewhere)

7000 The VFR code commonly used in Europe (Refer to ICAO standards)

0021 The VFR code commonly used in Germany (default is set to 0021 at time of

installation)

7500 Hijack code (Aircraft is subject to unlawful interference)

7600 Loss of communications

7700 Emergency

7777 Military interceptor operations (Never squawk this code)

0000 Military use (Not enterable)

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 283 284

Brak uwag

Side-Power SEP 100/185 T Instrukcja Obsługi Strona 170